Hydraulic Scissor Car Parking Lift

Hydraulic Scissor Car  Parking Lift Hydraulic Scissor Car  Parking Lift

The shift 35 car-lift is a very good system to replace garage access ramps (saving room) and to carry cars to upper floors. With this system one car remains underground leaving room on the top surface. Thus making cars independent, it is available also with a closing roof.

Technical Specification

Hydraulic and Electrical Safety

  1. Electrical end of run with micro switches at floors
  2. Manual lowering valve in case of power failure
  3. Parachute valve
  4. Going down control valve
  5. Load limiting valve

Floor Calling Buttons

  1. They are able to call the platform
  2. In the case one door should remain opened, the whole system will be locked
  3. Dead Man electrical controls

Hydraulic Power Unit

Constructed to modular oil-dynamic principles equipped with sheet tanks, level indicator, drain plug, immersion filter, gear wheel pump, nonreturn valve, simple solenoid electrovalve, maximum capacity valve, adjustment pistons flow dividers.

Electrical Controls: PLC System

PLC control system allows for additional doors and landing positions.

Installation Data

The pit construction should allow a 50 mm tolerance for each side and a 450 mm depth. Drawings available on request.

The system is delivered in 02 pieces,  I.E., If the platform is 6.000 x 3.000, the dimensions will be 6.000 x 1.500 x 450 mm.

Total weight of the system: from 3.800 Kg (Single scissor).

Hydraulic Scissor Car  Parking Lift Alternate Image 1 Hydraulic Scissor Car  Parking Lift Alternate Image 2 Hydraulic Scissor Car  Parking Lift Alternate Image 3 Hydraulic Scissor Car  Parking Lift Alternate Image 4