Shift 35 Hydraulic Scissor Car Parking Lift
The shift 35 car-lift is a very good system to replace garage access ramps (saving room) and to carry cars to upper floors. With this system one car remains underground leaving room on the top surface. Thus making cars independent, it is available also with a closing roof. See alternative Model Rex 30
Technical Specification
- Lifting system: single scissors equipped with 4 pistons with or without roof
- Capacity: up to 3500 kg. Higher capacities on request.
- Lifting Height: up to 3750 mm
- Platform: up to 6000x3000. Different measures on request
- Movement: electrohydraulic
- Electric Motor: 380/400 V, three-phase -7,5 kw, 50 HZ
- Controls: Dead Man Control
- Colour: according to customer requirements optional galvanising.
Hydraulic and Electrical Safety
- Electrical end of run with micro switches at floors
- Manual lowering valve in case of power failure
- Parachute valve
- Going down control valve
- Load limiting valve
Floors Calling Buttons
- They are able to call the platform
- In the case one door should remain opened, the whole system will be locked
- Dead Man electrical controls
Hydraulic Power Unit
Constructed to modular oil-dynamic principles equipped with sheet tanks, level indicator, drain plug, immersion filter, gear wheel pump, nonreturn valve, simple solenoid electrovalve, maximum capacity valve, adjustment pistons flow dividers.
Electrical Controls: PLC System
PLC control system allows for additional doors and landing positions.
Installation Data
The pit construction should allow a 50 mm tolerance for each side and a 450 mm depth. Drawings available on request.
The system is delivered in 02 pieces, I.E., If the platform is 6.000 x 3.000, the dimensions will be 6.000 x 1.500 x 450 mm.
Total weight of the system: from 3.800 Kg (Single scissor).